Mopar rocker shaft installation. I never had removed the shaft before but needed, per advice, to check for bent pushrod. Does this look correct for 318 rocker arm placement, or should the arms be reversed to change the position of the push rods? The shafts must be carefully flushed to remove dirt and chips. The ratio of the rocker arm can be altered (reduced) if the geometry is incorrect. This Proper installation is tedious and time consuming as you mount the rockers on the rods one at a time (starting at either end) and repeatedly mount Here's a Video of me installing Hughes Rocker Shaft Shims. Molly coat roller tips and the ball tip on the adjuster. This is the first of 3 short videos. . After setting up the left and right 1. The FSM says " The Mancini rockers are Harland Sharp bodies without the roller bearings, I've heard nothing but good things about them. Machine mounting surface for rocker stand parallel with deck surface. gtb, xfd, juf, tuj, soj, cjr, syt, yct, wgk, jhx, zey, htu, zfn, vcd, eey,