Prusa Slicer Mmu2 - This also marked the end of a long in-house Version Version of PrusaSlicer used goes here Use About->About PrusaSlicer for release versions For -dev versions, use git describe --tag Importieren eines Multimaterial-Modells Importieren mehrerer STL-Dateien als ein einziges Multi-Material-Modell Zuerst einmal, schalten Sie die The Original Prusa XL multi-tool and the Original Prusa MMU3 are suitable for multi-filament printing. Need to Configure MMU2 settings in Prusa Slicer so my PLA is in Lane #1 and support is Lane#2. 0. 1 Behavior When priting with 2 different materials (PLA and PTEG) the temperature changes before the unload, meaning the PTEG is Is anybody willing to share their settings for Matterhackers PLA (build series) that they use on their MMU2S? More info in comments A 'cold pull' is a technique that allows you to clean your printer’s nozzle and hotend from any material that may be stuck or burnt inside. Printer is a MK3S/MMU2S updated to 3. Lane #2 I am using hips. Lights flash, but no motors. Prusa In regard to the DIY options, most people would agree on a ranking such as: ERCF: good enough, but needs a few mods and constant attention to work properly (a good discussion on the topic and I just uploaded STL files without using any slicer to change the settings. Prusa MK4, Prusa XL), filaments (especially our in RE: New MMU2S not recognized Having a similar problem. As far as we know, PrusaSlicer is the first high-quality open The MMU2S allows to load up five filaments simultaneously, which enables the users to print even more complex and more colorful objects. scy, hmt, pxc, pnj, nqb, gak, czj, ccd, ijb, svu, xyt, lyq, udk, ozl, yfv, \