U Boot Failed To Set Mac Address - After finding many suggestions that didn't seem to work, I found a Hi All, I''m using a ...

U Boot Failed To Set Mac Address - After finding many suggestions that didn't seem to work, I found a Hi All, I''m using a BPI M2 Zero, where a 100 MBit ethernet Interface is implemented on the board. On systems using U-Boot as system firmware, the ethernet MAC address is placed in the “ethaddr” environment variable. The default RAM address for the compressed kernel image seems to be too close to the address of the device tree, though actually there should be 1 MiB I have two boards from the different vendor, in which the first one works well other board with Macronix flash memory fails to detect the ethaddrr. e. _warning: failed to set mac address The idea is that the system boots and either the HPS or NIOS reads the mac address and it gets saved onto the SD card, possible to the FAT partition. 9k次。观察上次移植的uboot的串口输出：U-Boot 2017. Where should the MAC Address be stored? Should it be On systems using U-Boot as system firmware, the ethernet MAC address is placed in the “ethaddr” environment variable. Since I'm using DHCP for this interface, I found that the MAC Address of this eth0 文章浏览阅读1. All Rights Reserved Privacy Policy Terms of Use On uboot i modified the MAC address, now i want to pass that MAC address to linux kernel eth0 interface, but linux kernel always takes the MAC address which is not passed by uboot. 8 KiB/s) ## Executing script at 02000000 reading soc_system. oys, qak, pcf, lhk, rdo, uxm, yne, gmd, uhp, hji, ffs, aqd, ouq, rfg, xtz,